Free Cisco 300-110 Exam Questions

A customer has a single anchor WLC named Anchor A. Anchor A is in a DMZ and provides guest access. The customer wants to deploy an additional anchor controller named Anchor B to provide redundancy if Anchor A fails. Which design approach should be taken for the guest WLAN priority on the foreign WLC for each anchor WLC?

A customer wants a network engineer to design a Cisco wireless solution that will have redundancy through SSO and LAG. APs in the executive office must reassociate to the WLC as soon as possible in the event of a failure. The WLCs are located in a remote data center. The head office uses a WAN for connectivity with the data center. Which priority must be incorporated in the design to be assigned to the executive APs?

An engineer is upgrading the legacy APs to 802.11ac Wave 2 capable APs. The existing gigabit uplinked switches provide 802.3at. Which switch limitation is a concern? 

A customer is planning to replace older access points with Cisco 4800 Series Access Points. Unaware of the infrastructure requirements, the client has an engineer investigate the inline power requirement. Which IEEE 802.3 standard complies with the Cisco 4800 Series Access Points? 

A community bank has three campus locations and one HQ with the data center. Each campus has four Cisco Catalyst 9120 APs. Poor WAN uplinks cause impacted connectivity back to HQ, and each campus is planned to have its own EWC controller based on C9120 AP to keep traffic local. Guest WLAN will be routed locally. Employee WLAN must be authenticated 802.1x PEAP via HQ ISE but can pass traffic locally once authenticated. HQ WLC will be the primary backup WLC for each WLC. Which design approach should the consulting engineer take?