Free Cisco 350-601 Exam Questions

Become Cisco Certified with updated 350-601 exam questions and correct answers

Page: 1 / 68

Total 340 Questions | Updated On: Apr 29, 2026

Add To Cart

Question 1

Refer to the exhibit. User1 and User2 are connected to VTEP1 switch. The users can reach the WEB server. The monitoring tool shows degrading network performance and excessive traffic is sent from User2 to reach the WEB server. Which storm control percentage levels must be used to suppress traffic from User2 and allow all traffic types from User1?

A : Level 0 on Eth1/1 and Level 100 on Eth1/2

B : Level 0 on Eth1/2 and Level 0 on Eth1/5

C : Level 0 on Eth1/2 and Level 100 on Eth1/1

D : Level 100 on Eth1/1 and Level 100 on Eth1/5

Answer: C

Question 2

What is the impact of an electronic programmable logic device upgrade on a Cisco MDS 9000 Series Director Switch with dual supervisors?

A : A manual reboot is required for each supervisor.c

B : Nondisruptive upgrades without traffic interruptions can be performed.

C : The upgrade is aborted if any module is unsupported.

D : A complete system reboot is triggered.

Answer: B

Question 3

An engineer is implementing VSAN 10 on multiple Cisco Nexus 5600 Series Switches and must ensure that the full zone set and active zone set are identical across the fabric. Which configuration must be implemented to meet this requirement?

A : switch(config)# zoneset distribute vsan 10

B : switch(config)#zoneset activate name ZONE10 vsan 10

C : switch(conftg)# zoneset distribute full vsan 10

D : switch(config)# zone-attribute-group name ATTR1 vsan 10

Answer: B

Question 4

What is the function of network file storage?

A : It provides file system access for storage devices

B : It uses Fibre Channel switches to store data at the block level.

C : It allows clients to access files stored on a remote server

D : It supports block-level system protocol used to access storage blocks

Answer: C

Question 5

Refer to the exhibit. An engineer must connect a Cisco MDS Series Switch to a Cisco UCS domain using a port channel, but the link fails to activate. Which command activates the interface?

A : switchport speed 8000

B : switchport trunk mode off

C : switchport rate-mode shared

D : switchport mode F

Answer: A

Page: 1 / 68

Total 340 Questions | Updated On: Apr 29, 2026

Add To Cart