Free Online Cisco 200-301 Practice Test

Prepare Your Cisco 200-301 Exam Questions with Free online 200-301 Practice Test. Get Brilliant Cisco Certified Network Associate Exam Results with Valid 200 301 Exam Dumps.

Page: 1 / 225

Total 1123 Questions | Updated On: Apr 22, 2024

Question 1

What is a reason to implement LAG on a Cisco WLC?

A : Increase the available throughput on the link.

B : Increase security by encrypting management frames

C : Allow for stateful failover between WLCs

D : Enable the connected switch ports to use different Layer 2 configurations

Answer: A

Question 2

Refer to the exhibit.

Which two commands must be configured on router R1 to enable the router to accept secure remote-access connections? (Choose two )

A : transport input telnet

B : crypto key generate rsa

C : ip ssh pubkey-chain

D : login console

E : username cisco password 0 Cisco

Answer: B,E

Question 3

Which action is taken by a switch port enabled for PoE power classification override?

A : When a powered device begins drawing power from a PoE switch port a syslog message is generated

B : As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused

C : If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects

D : Should a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

Answer: D

Question 4

Which statement about Link Aggregation when implemented on a Cisco Wireless LAN Controller is true?

A : To pass client traffic two or more ports must be configured.

B : The EtherChannel must be configured in 'mode active'

C : When enabled the WLC bandwidth drops to 500 Mbps

D : One functional physical port is needed to pass client traffic

Answer: D

Question 5

What is a requirement when configuring or removing LAG on a WLC?

A : The Incoming and outgoing ports for traffic flow must be specified If LAG Is enabled.

B : The controller must be rebooted after enabling or reconfiguring LAG.

C : The management interface must be reassigned if LAG disabled.

D : Multiple untagged interfaces on the same port must be supported.

Answer: C

Page: 1 / 225

Total 1123 Questions | Updated On: Apr 22, 2024