Free Cisco 300-620 Exam Questions

Become Cisco Certified with updated 300-620 exam questions and correct answers

Page: 1 / 59

Total 294 Questions | Updated On: Oct 24, 2026

Add To Cart

Question 1

How does Cisco ACI manage the old endpoint information on the original leaf switch after an endpoint moves between two Cisco ACI leaf switches?

A : A bounce entry is created by COOP communication instead of data plane learning.

B : A remote endpoint is created to represent the endpoint on another leaf.

C : Cisco APIC deletes an endpoint after receiving GARP packets from the new leaf.

D : The spine switch pushes all endpoint database entries to all leaf switches.

Answer: A

Question 2

Refer to the exhibit. A network engineer deploys Cisco APIC for the first time. Which connectivity type must be used to connect a Cisco ACI APIC node to connect to an out-of-band segment?

A : 4. 1-Gb Ethernet dedicated management port

B : 5. Serial port (RJ-45 connector)

C : 9. VIC 1455 with external 10/25-Gigabit Ethernet ports

D : 2. Dual 1-Gb/10-Gb Ethernet ports (LAN1 and LAN2)

Answer: D

Question 3

An engineer must advertise a bridge domain subnet out of the ACI fabric to an OSPF neighbor. Which two configuration steps are required? (Choose two.)

A : Add External Subnet for External EPG flag under External EPG

B : Configure Subnet scope to Advertised Externally

C : Configure the Subnet under the EPG level

D : Create Route Control Profile with the export direction under External EPG

E : Add L3Out profile to the bridge domain using Associated L3Outs section

Answer: B,E

Question 4

Which two statements regarding ACI Multi-Site are true? (Choose two.)

A : The Multi-Site orchestrator must be directly attached to one ACI leaf.

B : Routers in the Inter-Site network must run OSPF, DHCP relay, and MP-BGP.

C : ACI Multi-Site is a solution that supports a dedicated APIC cluster per site.

D : ACI Multi-Site is a solution that allows one APIC cluster to manage multiple ACI sites.

E : The Inter-Site network routers should run OSPF to establish peering with the spines.

Answer: C,E

Question 5

An engineer is implementing Cisco ACI at a large platform-as-a-service provider using APIC controllers, 9396PX leaf switches, and 9336PQ spine switches. The leaf switch ports are configured as IEEE 802.1p ports. Where does the traffic exit from the EPG in IEEE 802.1p mode in this configuration?

A : from leaf ports tagged as VLAN 0

B : from leaf ports untagged

C : from leaf ports tagged as VLAN 4094

D : from leaf ports tagged as VLAN 1

Answer: A

Page: 1 / 59

Total 294 Questions | Updated On: Oct 24, 2026

Add To Cart