Free Cisco 300-515 Exam Questions

Become Cisco Certified with updated 300-515 exam questions and correct answers

Page: 1 / 15

Total 74 Questions | Updated On: Jul 15, 2026

Add To Cart

Question 1

An ISP provides a major client MPLS VPN for managed services. The MPLS engineering team needs to use the advanced VPN feature of selective VRF import so that only specific prefixes are present in the required VPNs.

Which aspect of this feature must the team consider?

A : route must pass the import route map first and then the route target import filter.

B : routers that are imported in the VRF can be BGP and IGP routes, so other match conditions in the route map, besides communities, can be used.

C : import-map command is applied under the PE interface that connects to the CE router.

D : route is imported into the VRF only when at least one RT that is attached to the route matches one RT that is configured in the VRF and the route is permitted by the import route map.

Answer: D

Question 2

What is a requirement to share VRF reachability information to all members of a VPN when using IPv6?

A : and CE routers must be running BGP as the PE-CE routing protocol

B : routers must have MPLS disabled and be running MP-BGP between all P and PE routers.

C : routers must be running MP-BGP and bgp default ipv4-unicast must be disabled

D : l PEs must have the same VRFs configured.

Answer: D

Question 3

What do EVPN single-active and all-active have in common?

A : ey are default gateway redundancy options.

B : ey are multihoming mechanisms used for CE devices.

C : ey are used to provide single connection from a CE device to a service provider.

D : ey are both roles that a designated router can take when MPLS is used with EVPN.

Answer: D

Question 4

Refer to the exhibit.

Other-Image-4401f5183-2bb7-4027-a7be-479f8930a09a

If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

A : 1 must use OSPF to establish a neighbor relationship with PE1.

B : 1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.

C : 1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.

D : PE-CE routes between the devices are being exchanged by OSPF

E : 1 is supporting CSC.

Answer: A,D

Question 5

The network engineering group of a large ISP needs to harden the management plane of its Cisco 9000

Series ASRs. While addressing IPv6 ICMP issues, they realized they have to limit the rate at which IPv6 ICMP error messages are sent out on the network. Which command do they need to apply?

A : mp ipv6 rate-limit unreachable 1000

B : v6 rate-limit 1000

C : mp ipv4 rate-limit unreachable 1000

D : v6 icmp error-interval 50 20

Answer: D

Page: 1 / 15

Total 74 Questions | Updated On: Jul 15, 2026

Add To Cart