Free Cisco 350-801 Exam Questions

Become Cisco Certified with updated 350-801 exam questions and correct answers

Page: 1 / 89

Total 441 Questions | Updated On: Aug 20, 2026

Add To Cart

Question 1

0009700001

Refer to the exhibit. What is the registration state of the analog port in this debug output?

A : The analog port is currently shut down.

B : analog port is registered to Cisco UCM.

C : MGCP Gateway is not communicating with the Cisco UCM.

D : analog port failed to register to Cisco UCM with an error code 200.

Answer: B

Question 2

An administrator recently upgraded a Cisco Webex DX80 through its web interface but discovered the next morning that the unit has received to its previous version. What must the administrator do to prevent this from happening again?

A : ign a phone security profile with secure SIP.

B : t the prepare cluster for rollback to pre-8.0 enterprise parameter to true.

C : nfirm the phone load name in the phone configuration.

D : ign a universal device template to the phone.

Answer: C

Question 3

Refer to the exhibit.

A collaboration engineer configures Cisco UCM to act as a DHCP server. What must be done next to configure the DHCP server?

A : Restart the TFTP service under Cisco Unified Serviceability.

B : Add a DHCP subnet to the DHCP server under Cisco UCM Administration.

C : Add the new DHCP server to the primary DNS server.

D : Restart the Cisco DHCP Monitor Service under Cisco Unified Serviceability.

Answer: B

Question 4

0005600001

Refer to the Exhibit. Which command is required to allow this media resource to handle Video Media streams?

A : codec pass-through

B : associate application Cisco Unified Border Element

C : maximum sessions hardware 50

D : video codec h264

Answer: A

Question 5

Refer to the exhibit.

0004000001

Cisco Unified Border Element is attempting to establish a call with Subscriber 1, but the call fails. Cisco Unified Border Element then retries the same call with

Subscriber 2, and the call proceeds normally. Which action resolves the issue?

A : Verify that the Run On All Active Unified CM Nodes checkbox is enabled.

B : Verify that the correct calling search space is selected for the Inbound Calls section.

C : Verify that the Significant Digits field for Inbound Calls is set to All.

D : erify that the PSTN Access checkbox is enabled.

Answer: A

Page: 1 / 89

Total 441 Questions | Updated On: Aug 20, 2026

Add To Cart