Free Cisco 400-007 Exam Questions

Question 1

Which two fast reroute technologies provide the highest level of protected path coverage in a ring topology? (Choose two.)

A : r-prefix LFA

B : mote LFA

C : tomatic protection switching

D : LS TE FRR

E : r-link LFA

Answer: B,D

Question 2

Network designers often segment networks by creating modules for various reasons Sometimes however a network can be unintentionally segmented For instance, if the only way to connect a remote site to a headquarters or regional site is to connect them both to the public Internet the corporate network is now unintentionally segmented Which of the following option can be used to desegment the network in this situation?

A : Build virtual networks that pass over the network

B : Mark traffic for special handling through quality of service

C : Configure little to no control data plane policy

D : Block specific sources from reaching specific destinations

Answer: A

Question 3

You work for a large enterprise network that spans many remote locations and uses EIGRP as its only routing protocol. Recently, the network grew too rapidly and it is having a lot of SIA problems, which impact the company business. In which two ways should you redesign the network to solve this problem? (Choose two.)

A : iminate the use of secondary networks.

B : plement EIGRP Wide Metrics

C : iminate duplicate router IDs.

D : plement route summarization.

E : plement EIGRP Stub on remote locations.

Answer: A,D

Question 4

Network designers often segment networks by creating modules for various reasons Sometimes however a network can be unintentionally segmented For instance, if the only way to connect a remote site to a headquarters or regional site is to connect them both to the public Internet the corporate network is now unintentionally segmented Which of the following option can be used to desegment the network in this situation?

A : Build virtual networks that pass over the network

B : Mark traffic for special handling through quality of service

C : Configure little to no control data plane policy

D : Block specific sources from reaching specific destinations

Answer: A

Question 5

What are two common approaches to analyzing and designing networks? (Choose two.)

A : ttom-up approach

B : gh-low security approach

C : p-down approach

D : ft-right approach

E : ree-tier approach

Answer: A,C