Free Fortinet FCSS_NST_SE-7.4 Exam Questions

Become Fortinet Certified with updated FCSS_NST_SE-7.4 exam questions and correct answers

Page: 1 / 14

Total 66 Questions | Updated On: Dec 05, 2025

Add To Cart

Question 1

Refer to the exhibit, which shows partial outputs from two routing debug commands.Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?

A : Set snat-route-change to enable.

B : Set the priority of the static default route using port2 to 1.

C : Set preserve-session-route to enable.

D : Set the priority of the static default route using port1 to 10.

Answer: D

Question 2

Exhibit.Refer to the exhibit, which shows the output of diagnose automation test.What can you observe from the output? (Choose two.)

A : The automation stitch test is not being logged.

B : The automation stitch test failed but the HA failover was successful.

C : An HA failover occurred.

D : The test was unsuccessful.

Answer: A,D

Question 3

The local OSPF router is unable to establish adjacency with a peer. Which two things should the administrator do to troubleshoot the issue? (Choose two.)

A : Check whether TCP port 179 is blocked.

B : Check if there is an active static route to the peer.

C : Check whether both peers have an IP address within the same subnet.

D : Check if IP protocol 89 is blocked.

Answer: C,D

Question 4

Refer to the exhibit, which shows the output of a debug command.Which two statements about the output are true? (Choose two.)

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Question 5

Refer to the exhibit, which shows the output of a debug command.Which two statements about the output are true? (Choose two.)

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Page: 1 / 14

Total 66 Questions | Updated On: Dec 05, 2025

Add To Cart