Free Fortinet FCSS_NST_SE-7.6 Exam Questions

Become Fortinet Certified with updated FCSS_NST_SE-7.6 exam questions and correct answers

Page: 1 / 27

Total 132 Questions | Updated On: Jul 15, 2026

Add To Cart

Question 1

What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow? (Choose two.)

A : Packet was dropped because of policy route misconfiguration.

B : Packet was dropped because of traffic shaping.

C : Trusted host list misconfiguration.

D : VIP or IP pool misconfiguration.

Answer: C,D

Question 2

Refer to the exhibits.An administrator Is expecting to receive advertised route 8.8.8.8/32 from FGT-A. On FGT-B, they confirm that the route is being advertised and received, however, the route is not being injected into the routing table. What is the most likely cause of this issue?

A : A batter route to the 8.8.8.8/32 network exists in the routing table.

B : FGT-B is configured with a prefix list denying the 8.8.8.8/32 network to be injected into the routing table.

C : The administrator has misconfigured redistribution of routes on FGT-A.

D : FGT-8 is configured with a distribution list denying the 8.8.8.8/32 network to be injected into the routing table.

Answer: B

Question 3

Refer to the exhibit, which shows the omitted output of a session table entry.Which two statements are true? (Choose two.)

A : The traffic has been tagged for VLAN 0000.

B : NP7 is handling offloading of this session.

C : The traffic matches Policy ID 1.

D : The session has been offloaded.

Answer: C,D

Question 4

Refer to the exhibit, which shows the output of a policy route table entry.Which type of policy route does the output show?

A : An ISDB route

B : A regular policy route

C : A regular policy route, which is associated with an active static route in the FIB

D : An SD-WAN rule

Answer: A

Question 5

Refer to the exhibit, which shows the output of a debug command.Which two statements about the output are true? (Choose two.)

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Page: 1 / 27

Total 132 Questions | Updated On: Jul 15, 2026

Add To Cart