Free SAP C_IBP_2502 Exam Questions

Become SAP Certified with updated C_IBP_2502 exam questions and correct answers

Page: 1 / 33

Total 163 Questions | Updated On: Jun 26, 2025

Add To Cart

Question 1

Which of the following are features of the S&OP process templates? Note: There are 2 correct Answers to this question

A : All process templates are assigned to dashboards.

B : The number of steps in a process template is the same for all implementations.

C : Each step depicted in the template can have tasks associated with it.

D : New instances of templates allow for re-use of the same processes again.

Answer: C,D

Question 2

While modeling for a large machine with high capital needs, you need it to run cost effectively with minimum utilization, even if it means producing more than demand. Which solution would apply to this scenario? Note: There are 2 correct Answers to this question.

A : Capacity leveling will be possible for production and storage resources.

B : Excess stock can be generated and will need to be staged in an overflow warehouse.

C : Enough demands can be pulled forward and pull production will occur.

D : Balance can be achieved between excessive prebuild and minimum utilization by incorporating violation costs.

Answer: C,D

Question 3

You are starting a new implementation project for SAP IBP and are considering the possible system architecture.What are the possible approaches for setting up the system landscape?Note: There are 2 correct answers to this question.

A : Create additional planning areas in the test system to support training needs.

B : Set up a three-tier landscape using transport, starting from the development system to test and production.

C : Set up a two-tier landscape, and have the configuration of the development system regularly updated from the production system.

D : Create additional test planning areas in the production system to support cutover needs.

Answer: B,C

Question 4

You create an S&OP operator for heuristics on an SAP IBP project. What must you enable for the S&OP operator that is specifically relevant for subnetworks?

A : Compute Expected Supply parameter

B : Balance Receipts parameter

C : Normalize Quotas parameter

D : Supply propagation

Answer: A

Question 5

What are the possible ways that an attribute intended for use as an attribute as a key figure can be created and assigned?

A : Created as type NVARCHAR and assigned to an external master data type

B : Created as type INTEGER and assigned to a compound master data type

C : Created as type INTEGER and assigned to a simple master data type

D : Created as type DECIMAL and assigned to a compound master data type

Answer: C,D

Page: 1 / 33

Total 163 Questions | Updated On: Jun 26, 2025

Add To Cart