Free Nutanix NCP-CI-Azure Exam Questions

Become Nutanix Certified with updated NCP-CI-Azure exam questions and correct answers

Page: 1 / 16

Total 77 Questions | Updated On: Oct 27, 2025

Add To Cart

Question 1

An administrator is planning to expand an NC2 on Azure cluster. Which statement is true regarding prerequisites for expanding the cluster?

A : Cluster must be in a Cluster Stopped state.

B : Cluster must have at least three nodes.

C : Cluster must be in a Cluster Connected state.

D : Cluster must have at least five nodes.

Answer: C

Question 2

An on-premises network has been extended to azure with a VPN/ExpressRoute. The routing and peering of VNets is setup and has been confirmed to be correct. Which statement best describes the state of the traffic flow between the on-prem CVMs and the NC2 CVMs in Azure?

A : The Network Security Group of the Flow Gateway VM on the Internal NICs will need to be edited to enable the traffic flow.

B : A ticket will need to be put in with Microsoft support to open the subnet ranges from on-premises.

C : Traffic will flow directly to the NC2 CVMs. Nothing will block the path by default.

D : The Network Security Group of the Flow Gateway VM on the Externa! NICs will need to be edited to enable the traffic flow.

Answer: A

Question 3

An administrator needs to extend an on-premises subnet to an NC2 cluster on Azure. Which set of options should the administrator configure to complete this task?

A : Subnet Type: VPC subnets Traffic Type: IPv4 unicast traffic and ARP On-premises Hypervisor: ESXi, AHV, Hyper-V

B : Subnet Type: On-premises VLAN subnets and VPC subnets Traffic Type: IPv4 unicast traffic IPv6 unicast traffic and ARP On-premises Hypervisor: ESXi and AHV

C : Subnet Type: On-premises VLAN subnets and VPC subnets Traffic Type: IPv4 unicast traffic and ARP On-premises Hypervisor: AHV

D : Subnet Type: On-premises VLAN subnets and VPC subnets Traffic Type: IPv6 umcasi traffic and ARP On-premises Hypervisor: Hyper-V

Answer: B

Question 4

Exhibit.

AN NC2 on Azure Cluster was deployed with two Flow gateways in HA (FGW1 and FGW2). After a week of use. Four bare-metal nodes, were added to the NC2 cluster and additional workloads were added. It was determined that additional bandwidth for north/South traffic would be needed. Two additional Flow gateways were added (FGW3 and FGW4) from the NC2 portal configuration menu. The existing workloads prior to expansion on the NC2 cluster will be able to use which Flow Gateways using the No-Nat (routed) traffic path?

A : Only the Flow Gateway that each workload was originally using.

B : All Flow Gateways can be used.

C : All Flow Gateways can be used after the existing workloads reboot.

D : FGW1&FGW2 only, new workloads can use FGW3 & FGW4.

Answer: B

Question 5

A company has just adopted Nutanix as their technology of choice and is preparing to deploy Nutanix Cloud Clusters (NC@) Which step must be taken first to gain access to the NC2 console?

A : Start a free trial via Billing Portal.

B : Navigate to doud.nutanix.com.

C : Create a My Nutanix account.

D : Open a support case with Nutanix.

Answer: C

Page: 1 / 16

Total 77 Questions | Updated On: Oct 27, 2025

Add To Cart