Free NVIDIA NCP-AII Exam Questions

Become NVIDIA Certified with updated NCP-AII exam questions and correct answers

Page: 1 / 15

Total 72 Questions | Updated On: Aug 19, 2026

Add To Cart

Question 1

After NCCL burn-in reports "transport retry count exceeded," which corrective action addresses theunderlying fabric issue?

A : Switch from Ring to Tree algorithms via NCCL_ALGO=TREE

B : Reduce message size to decrease network utilization

C : Increase NCCL_IB_TIMEOUT to tolerate longer latencies

D : Inspect InfiniBand link quality metrics (BER, symbol errors) and replace faulty cables

Answer: D

Question 2

An engineer needs to verify the current firmware versions of all components (ATF, BSP, NIC, UEFI) ona BlueField-3 DPU's BMC. Which Redfish API command provides this information?

A :

B :

C :

D :

redfish/v1/UpdateService/FirmwareInventory

Answer: D

Question 3

During East-West fabric validation on a 64-GPU cluster, an engineer runs all_reduce_perf andobserves an algorithm bandwidth of 350 GB/s and bus bandwidth of 656 GB/s. What does thisindicate about the fabric performance?

A : Inconclusive; rerun with point-to-point tests.

B : Optimal performance; bus bandwidth near theoretical peak for NDR InfiniBand.

C : Critical failure; bus bandwidth exceeds hardware capabilities.

D : Suboptimal performance; algorithm bandwidth should match bus bandwidth.

Answer: B

Question 4

For an NVIDIA Enterprise AI Factory with 256 GPUs, which storage solution characteristic is mostcritical to validate during scaling tests?

A : Consistent per-node throughput >8 GiB/s.

B : Single-node write performance during idle clusters.

C : RAID rebuild times under disk failure.

D : Maximum 4K random read IOPS exceeding 1 million.

Answer: A

Question 5

After configuring NGC CLI with ngc config set, a user receives Authentication failed errors whenpulling containers. What step was most likely omitted?

A : Installing the CLI with apt-get instead of manual extraction.

B : Entering the API key during ngc config set or storing it in ~/.ngc/config.

C : Setting --format_type=json to enable API interactions.

D : Running sudo systemctl restart docker after configuration.

Answer: B

Page: 1 / 15

Total 72 Questions | Updated On: Aug 19, 2026

Add To Cart