Free Juniper JN0-682 Exam Questions

Become Juniper Certified with updated JN0-682 exam questions and correct answers

Page: 1 / 31

Total 155 Questions | Updated On: Jul 28, 2025

Add To Cart

Question 1

You are deploying a 3-stage Clos IP fabric in your data center. In this scenario, which statement is correct?

A : ch server-facing interface on a leaf node is always three hops away from other server-facing interfaces.

B : ch spine node must be physically connected to all other spine nodes.

C : ere is an eight-spine node limitation.

D : direct physical connections exist between leaf nodes.

Answer: A

Question 2

You are building a new IP fabric data center underlay network and want to ensure predicted load- balancing behavior for traffic, traversing the fabric. What are two approaches you should take to satisfy the requirement in this scenario? (Choose two.)

A : ure that all spine devices are the same switched mode.

B : ure that all uplinks are 40GbE.

C : ure that every leaf node has an uplink spine node

D : ure that every node has a link to every other leaf node

Answer: A,C

Question 3

Which statement is correct about the highlighted code segment and VXLAN frame shown in the exhibit?

A : This statement is optional and keeps the VLAN header in the Original L2 Frame, if included.

B : This statement is optional and removes the VLAN header in the Original L2 Frame, if included.

C : This statement is required and removes the VLAN header in the Original L2 Frame, if included.

D : This statement is required and keeps the VLAN header in the Original L2 Frame, if included.

Answer: A

Question 4

What is the endpoint of a VXLAN tunnel?

A : CI

B : EP

C : R

D : F

Answer: B

Question 5

You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish.

Why is the BGP session failing to establish?

A : route-distinguisher value on the local PE is incorrect

B : ere is no route for 192.168.5.5 an VPN net 0.

C : ere is no route for 192.168.5.5. in inet 3.

D : vrf-table abel value is not configured in the remote PE.

Answer: C

Page: 1 / 31

Total 155 Questions | Updated On: Jul 28, 2025

Add To Cart