Free Juniper JN0-664 Exam Questions

Become Juniper Certified with updated JN0-664 exam questions and correct answers

Page: 1 / 19

Total 91 Questions | Updated On: Oct 25, 2026

Add To Cart

Question 1

Exhibit

You want to use both links between R1 and R2 Because of the bandwidth difference between the two links, you must ensure that the links are used as much as possible. Which action will accomplish this goal?

A : fine a policy to tag routes with the appropriate bandwidth community.

B : able multipath.

C : ure that the metric-out parameter on the Gigabit Ethernet interface is higher than the 10 Gigibit Ethernet interface.

D : able per-prefix load balancing.

Answer: D

Question 2

You are configuring a BGP signaled Layer 2 VPN across your MPLS enabled core network. Your PE-2 device connects to two sites within the s VPN In this scenario, which statement is correct?

A : default on PE-2, the site's local ID is automatically assigned a value of 0 and must be configured to match the total number of attached sites.

B : u must create a unique Layer 2 VPN routing instance for each site on the PE-2 device.

C : u must use separate physical interfaces to connect PE-2 to each site.

D : default on PE-2, the remote site IDs are automatically assigned based on the order that you add the interfaces to the site configuration.

Answer: D

Question 3

Which two statements are correct about VPLS tunnels? (Choose two.)

A : P-signaled VPLS tunnels only support control bit 0.

B : P-signaled VPLS tunnels use auto-discovery to provision sites

C : P-signaled VPLS tunnels can use either RSVP or LDP between the PE routers.

D : P-signaled VPLS tunnels require manual provisioning of sites.

Answer: B,C

Question 4

Which three mechanisms are used by Junos platforms to evaluate incoming traffic for CoS purposes? (Choose three )

A : write rules

B : havior aggregate classifiers

C : affic shapers

D : xed classifiers

E : ltifield classifiers

Answer: A,B,D

Question 5

Which two statements are correct about reflecting inet-vpn unicast prefixes in BGP route reflection? (Choose two.)

A : ute reflectors do not change any existing BGP attributes by default when advertising routes.

B : BGP peer does not require any configuration changes to become a route reflector client.

C : ients add their originator ID when advertising routes to their route reflector

D : ute reflectors add their cluster ID to the AS path when readvertising client routes.

Answer: A,B

Page: 1 / 19

Total 91 Questions | Updated On: Oct 25, 2026

Add To Cart