Free Juniper JN0-649 Exam Questions

Become Juniper Certified with updated JN0-649 exam questions and correct answers

Page: 1 / 13

Total 65 Questions | Updated On: Jul 28, 2025

Add To Cart

Question 1

Referring to the exhibit, which statement is correct when a failure exists on the link between host2 and switch5 on this EVPN-VXLAN fabric?

A : switch5 device will send a Type 2 route to all peers.

B : switch5 device will send a Type 4 route to all peers.

C : switch5 device will send a Type 1 route to all peers.

D : switch5 device will send a Type 3 route to all peers.

Answer: D

Question 2

Referring to the exhibit, which two statements are correct? (Choose two.)

A : DUs from the root bridge for VLAN 10 have been received on the ge-0/0/7.0 interface.

B : -1 is the root bridge for VLAN 10.

C : DUs from the root bridge for VLAN 20 have been received on the ge-0/0/7.0 interface.

D : fault VSTP bridge priority values are configured.

Answer: A,C

Question 3

Referring to the exhibit, which two statements are correct? (Choose two.)

A : maximum wattage that this switch can allocate to attached Ethernet devices is 100 watts.

B : the total power consumption exceeds 90 watts, the ge-0/0/11 interface will continue to receive power.

C : is not enabled on the ge-0/0/0 interface.

D : ge-0/0/10 interface supports PoE+.

Answer: A,C

Question 4

The connection between DC1 and DC2 is routed as shown in the exhibit.

In this scenario, which statement is correct?

A : border devices must be able to perform Layer 3 routing and provide IRB functionality.

B : VPN must be enabled to advertise reachability.

C : IP prefix route provides encoding for intra-subnet forwarding.

D : pe 2 and Type 5 routes will be exchanged between DC1 and DC2.

Answer: A

Question 5

You have scheduled maintenance operations for one of the devices in your OSPF network.

Referring to the exhibit, which three statements are correct? (Choose three.)

A : does not participate in OSPF routing.

B : y traffic destined for networks that terminate on R1 will still be forwarded to R1.

C : metrics for all transit interfaces on R1 is set to the maximum value of 65,535.

D : participates in OSPF routing but does not send or receive transit traffic.

E : does not send or receive transit traffic during the maintenance window even if no alternative paths exist to the given destination.

Answer: B,C,D

Page: 1 / 13

Total 65 Questions | Updated On: Jul 28, 2025

Add To Cart