Free Juniper JN0-363 Exam Questions

Become Juniper Certified with updated JN0-363 exam questions and correct answers

Page: 1 / 20

Total 100 Questions | Updated On: Dec 18, 2025

Add To Cart

Question 1

You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority

has been configured. Which statement is true in this scenario?

A : device with the lowest MAC address will be elected as the root bridge.

B : device with the highest MAC address will be elected as the root bridge.

C : device with the lowest numerical lo0 IP address will be elected as the root bridge.

D : device with the highest numerical lo0 IP address will be elected as The bridge.

Answer: A

Question 2

Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

A : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will be dropped.

B : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will be dropped.

C : Traffic ingressing ge-1/0/0 that is tagged with VLAN 100 will egress ge-1/0/4 with an outer VLAN tag of 200.

D : Traffic ingressing ge-1/0/0 that is tagged with VLAN 200 will egress ge-1/0/4 with an outer VLAN tag of 200

Answer: A,C

Question 3

You are deploying an MC-LAG connection at the edge of your network to a new customer. This solution must ensure that traffic uses all available links when forwarding traffic between the two networks.In this scenario, which two statements are correct? (Choose two.)

A : Transit traffic sent between the two PE devices will use the ICL interface.

B : You must use active/active mode when defining the MC-LAG bundle.

C : You must use active/standby mode when defining the MC-LAG bundle.

D : Transit traffic sent between the two PE devices will use the bundle’s member interfaces.

Answer: A,B

Question 4

Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24,

172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route

hidden.

Which action would you perform to determine the problem?

A : Verify that you have active contributing routes on the device.

B : Verify that you have configured a policy on the device to accept aggregate routes.

C : Verify that you have defined a metric value for the aggregate route.

D : Verify that you have set the preference to a lower default value.

Answer: D

Question 5

Exhibit

You want the R1 and R3 routers to forward traffic destined to the 203.0.113.0/24 network through R2. Which

BGP attribute would you modify to satisfy this requirement?

A : mmunity

B : igin

C :

D : cal preference

Answer: C

Page: 1 / 20

Total 100 Questions | Updated On: Dec 18, 2025

Add To Cart