Free ISA-IEC ISA-CAP Exam Questions

Question 1

What is a cost-effective method of mitigating the effects of deep voltage sags on programmable electronic devices and preventing power interruptions or shutdowns in critical industrial manufacturing processes?

A : Using a dynamic voltage restorer (DVR) to inject the required voltage to compensate for the voltage sag and maintain the load voltage

B : Using a static synchronous compensator (STATCOM) to regulate the reactive power and improve the power factor and voltage stability

C : Using a unified power quality conditioner (UPQC) to correct both voltage and current disturbances and provide a clean power supply

D : Using a superconducting magnetic energy storage (SMES) system to store and release energy quickly and efficiently

Answer: A

Question 2

What is the name of the device that can detect water level in a well pump and shut off the power to the pump if it senses a dry run condition?

A : Pump controller

B : Float switch

C : Cycle sensor

D : Leak defender

Answer: A

Question 3

What is the next best course of action after troubleshooting a system failure by replacing a suspected bad component with a known good component and finding that this does not correct the problem?

A : Replace another component that is related to the problem and test again

B : Consult a third person who has advanced knowledge about the system or the principles

C : Remove devices one at a time and test again

D : Insert faults into the system and observe the response

Answer: A

Question 4

Which of the following statements BEST describes the difference between an alarm system and a safety system?

A : n alarm system alerts the operator of an abnormal condition that requires a timely response, while a safety system automatically takes corrective actions to prevent or mitigate hazardous consequences.

B : An alarm system records the video footage of the events occurring on the property, while a safety system uses motion sensors and other equipment to detect intrusions and notify the authorities.

C : An alarm system applies human factors and ergonomics to design an alarm interface that increases usability, while a safety system monitors and assesses the performance of the alarm system against predefined targets.

D : An alarm system creates a loud noise or flashing lights to scare away potential intruders, while a safety system contacts the homeowners or local authorities once the alarm sounds.

Answer: A

Question 5

What is a cost-effective method of mitigating the effects of deep voltage sags on programmable electronic devices and preventing power interruptions or shutdowns in critical industrial manufacturing processes?

A : Using a dynamic voltage restorer (DVR) to inject the required voltage to compensate for the voltage sag and maintain the load voltage

B : Using a static synchronous compensator (STATCOM) to regulate the reactive power and improve the power factor and voltage stability

C : Using a unified power quality conditioner (UPQC) to correct both voltage and current disturbances and provide a clean power supply

D : Using a superconducting magnetic energy storage (SMES) system to store and release energy quickly and efficiently

Answer: A