Free Online HP HPE6-A69 Practice Test

Prepare Your HP HPE6-A69 Exam Questions with Free online HPE6-A69 Practice Test. Get Brilliant Aruba Certified Switching Expert Written Exam Results with Valid HPE6 A69 Exam Dumps.

Page: 1 / 12

Total 60 Questions | Updated On: May 14, 2024

Add To Cart

Question 1

What are the requirements for managing a switch using Aruba NetEdit? (Select two)

A : REST access-mode must be set to read-write.

B : HTTPS service must be restricted to the management VRF

C : The switch user account mat NetEdit uses should have a password.

D : Telnet must be disabled on the switch

Answer: A,D

Question 2

Which MAC address is valid for use as a VSX System-MAC address?

A : B:00:04:00:FF:00

B : 0A:00:00.00.00

C : FF:00:00:00:00:00

D : 01:00:5E40:10.01

Answer: B

Question 3

You are working with a customer whos has a paw of Aruba 8325 switches configured for Multi-Chassis Link Aggregation The customer is complaining that users are experiencing intermittent packet drops. Which action should be taken to quickly aid you in identifying the cause?

A : Enable debug of vri with 'console' set as the destination

B : Setup a mirror session to generate a Tshark file.

C : Setup a mirror session to niter packets for TCPDUMP analysis

D : Check the configured VLANs using 'show vsx config-consistency'

Answer: D

Question 4

A customer with an ArubaOS-CX 6300M switch is having a performance issue on the network and has received complaints about users experiencing intermittent connectivity. After performing troubleshooting it is determined that many of the local websites on the LAN that users are unable to reach are resolved to an invalid MAC address

What are the minimum steps that should be performed to mitigate this condition? (Select two.)

A : implement dhcpv4-shooping.

B : Implement ARP ACLs to define trusted MAC address to IP bindings

C : Enable 'arp inspection' on the end-user physical ports

D : Enable 'arp inspection untrusted' on the end-user physical ports

E : Enable 'arp inspection' on the end-user VLAN

Answer: A,B

Question 5

(Scenarios may contain multiple errors which may or may not impact the solution )

Refer to the exhibit.

Other-Image-3c72102f9-c60c-4920-9ee8-e2be87fe8f9c

An engineer has attempted to configure two pairs of switches in the referenced configuration It is required to implement VSX at the aggregation layer

The pons of the ArubaOS-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

Other-Image-6c72102f9-c60c-4920-9ee8-e2be87fe8f9c

The configuration of switch AGG01 includes

Other-Image-8c72102f9-c60c-4920-9ee8-e2be87fe8f9c

The VSX cluster is not forming. Which modification should you make to resolve the error condition?

A : Modify the system interface-group 4 speed tOg command change '25g' to '10g'

B : Modify the keepalive peer 192.168 20.2 source 192 168.20 1 command, changing 'vrf KA' to 'vrf mgmt'

C : Edit the vsx-sync command, adding 'keep-alive'

D : Modify the vsx definition, changing 'inter-switch-link lag 2' to' inter-switch-link lag 256'

Answer: A

Page: 1 / 12

Total 60 Questions | Updated On: May 14, 2024

Add To Cart