Free Pure Storage FlashArray-Implementation-Specialist Exam Questions

Become Pure Storage Certified with updated FlashArray-Implementation-Specialist exam questions and correct answers

Page: 1 / 48

Total 236 Questions | Updated On: Jun 16, 2026

Add To Cart

Question 1

Where can the NVRAM on a FlashArray//E be located?

A : Distributed across DFMes

B : Distributed across DFMDs

C : Within the dedicated NVRAMS

Answer: B

Question 2

A customer has scheduled the installation of a FlashArray//X70R4. Core services such as DNS, NTP, and SMTP are currently unavailable due to a network outage, but the Implementation Engineer proceeds with the installation as planned. What should the Implementation Engineer expect during the installation?

A : The array will automatically skip configuration of all network-dependent features and require a full reinitialization later.

B : Purity will set itself to NOT start on bootup due to services unable to be verified during installation.

C : Core service validation checks will fail during setup, but the installation can complete and services can be verified later once restored.

D : The puresetup command will lock the array into maintenance mode until Pure Support authenticates the bypass.

Answer: C

Question 3

Refer to the following output: Ping successful with CCM What does this indicate?

A : Controller has successfully connected to pure1

B : Controller has successfully connected to the Fusion Fleet Coordinator

C : Cross-controller link has successfully connected between controllers

Answer: A

Question 4

During a hardware NDU from FlashArray//XR2 or XR3 to an XR4 model, which default service on-board ports are NO longer present in the XR4 controller design?

A : iSCSI

B : Replication

C : Management

Answer: A

Question 5

The Pure Engagement Request (PER) specifies that iSCSI ports ETH2 and ETH3 should be set to 10 Gb/s. After configuring the ports and connecting them to the SAN, the Implementation Engineer observes that ETH2 /3 are not negotiating and display 0 b/s. The SAN is operating at 40 Gb/s, with support for up to 100 Gb/s. What should the Implementation Engineer do to resolve this issue and complete the install?

A : Force negotiate the array iSCSI ports to 40 Gb/s.

B : Replace the transceivers with the appropriate type.

C : Force negotiate the switch iSCSI ports to 40 Gb/s.

Answer: B

Page: 1 / 48

Total 236 Questions | Updated On: Jun 16, 2026

Add To Cart