Free CWNP CWDP-305 Exam Questions

Become CWNP Certified with updated CWDP-305 exam questions and correct answers

Page: 1 / 65

Total 322 Questions | Updated On: Jan 28, 2026

Add To Cart

Question 1

After deploying a 5 GHz-only WLAN infrastructure in the USA, using 20 MHz channel widths and all 25 available channels, a manager tests the Guest SSID on his 802.11n tablet. During testing, he experiences several areas with poor RSSI (below -80 dBm) or no signal at all. Upon checking, all APs are operational, and coverage was validated post-deployment. What is the likely cause of this issue?

A : His tablet doesn't support the 5 GHz band

B : His tablet only supports a 40 MHz channel-width

C : His tablet does not support one or more of the 5 GHz channels

D : His tablet doesn't support MU-MIMO

Answer: C

Question 2

Which one of the following might be detected as a source of CCI during a post-validation survey in the 5 GHz band?

A : Other OFDM networks

B : Other ERP networks

C : Microwave ovens

D : Other HR/DSSS networks

Answer: A

Question 3

Which document provided to your customer should include all devices and parts that are going to be used during the deployment of their WLAN infrastructure?

A : SoW

B : BoM

C : Design report

D : Project plan

Answer: B

Question 4

Which definition correctly describes the "local MAC" variation of the centralized WLAN architecture?

A : All MAC functions are performed by the AP. A minimal subset of network control is offloaded to the WLAN controller along with management and monitoring functions.

B : PHY functions are performed directly by the AP. MAC functions are divided almost equally between the WLAN controller and the AP, according to the time sensitivity of the feature or service.

C : The AP provides the RF termination point for the WLAN, but performs very few of the WLAN functions or services. The WLAN controller performs all MAC functions and the AP is very simple and lightweight.

D : All RF-, data-, and control-related WLAN functions are performed by the AP. APs coordinate network services with one another and are managed by a WNMS.

Answer: A

Question 5

When viewing channel utilization information from a protocol analyzer, if high channel utilization is occurring, what should you ensure does not exist?

A : A high percentage of low PHY rates

B : An RF signal generator causing an RF DoS

C : High levels of workload

D : High frames per second

Answer: B

Page: 1 / 65

Total 322 Questions | Updated On: Jan 28, 2026

Add To Cart