Free iSQI CTAL-TAE_V2 Exam Questions

Become iSQI Certified with updated CTAL-TAE_V2 exam questions and correct answers

Page: 1 / 48

Total 236 Questions | Updated On: Oct 25, 2026

Add To Cart

Question 1

The test automation solution you are using has been operating for three years. One problem you've identified is the increasing number of false-positive results, which require a lot of investigation and troubleshooting work.Whenever new scripts are developed, it seems like a few additional ones are added even if every one of them is fixed when it is discovered.What is the most likely issue with the TAS that is causing the introduction of these false-positives?

A : The verification functions are not standardized; instead of using a standard verification technique, they are implemented specifically for each script

B : There is incompatibility between TAS and SUT error recovery techniques

C : The software is not waiting for a response from the preceding action, and the wait mechanisms are incorrect

D : The test cases and test steps overlap, which makes a change in one place break the same code that is utilized in another

Answer: A

Question 2

Which factor is essential to consider when selecting test automation tools?

A : The popularity of the tool among testers in the industry

B : The number of features offered by the tool

C : The availability of support for every tool

D : The costs associated with the test automation tools and features

Answer: D

Question 3

Automated tests run by a TAS on a SUT can be subject to sudden bursts of messages to log during their execution. All log messages that occur during execution must be permanently stored in the corresponding test execution logs by the TAS for later analysis. If logging is not performed correctly, these bursts can reduce the execution speed of these automated tests, causing them to produce unreliable results. Which of the following solutions would you expect to be MOST useful to address this issue for TAS logging?

A : Use a Network Time Protocol (NTP) server to ensure that the clocks of the machines running TAS and SUT are synchronized with a common time source

B : Log all the messages in memory using a circular buffer and periodically flush the buffer to the corresponding log files associated with the specific execution

C : Avoid logging the messages that occur during the specified bursts to minimize any potential performance overhead in test execution

D : Log all the messages directly on the corresponding log files associated with the specific execution to ensure the permanent storage of test execution logs

Answer: B

Question 4

What is a key characteristic of the gTAA when implementing a TAS?

A : It restricts the use of off-the-shelf tools and requires custom-built components

B : It is limited to a predefined set of technologies that are specified by test automation vendors

C : It is vendor-neutral and can be implemented using any software engineering approach or tools

D : It mandates the use of specific vendor tools and technologies for test automation

Answer: C

Question 5

Consider a defect is found in the current release of the software.In your opinion, which of the following best explains why a defect of this nature might recur in later releases?

A : Automated re-testing of defects is ineffective in verifying that the fixed defect will function as intended in subsequent releases

B : The synchronization between multiple software archives is not properly controlled by the configuration management process

C : The automated defect re-test typically has a smaller functional scope than other automated tests

D : The automated defect re-test is not added to the automated regression test suite that will be run in future releases

Answer: B

Page: 1 / 48

Total 236 Questions | Updated On: Oct 25, 2026

Add To Cart