Free SMRP CMRP Exam Questions

Become SMRP Certified with updated CMRP exam questions and correct answers

Page: 1 / 30

Total 150 Questions | Updated On: Jan 21, 2024

Add To Cart

Question 1

Percent overtime maintenance labor hours is:

A : Overtime maintenance labor hours used to maintain assets, divided by the total maintenance labor hours to maintain assets, expressed as a percentage.

B : Total overtime labor hours, divided by the total scheduled maintenance labor hours, expressed as a percentage.

C : Total overtime labor hours, divided by the total maintenance labor hours to maintain assets, expressed as a percentage.

D : Scheduled overtime maintenance labor hours used to maintain assets, divided by scheduled maintenance labor hours to maintain assets, expressed as a percentage.

Answer: A

Question 2

Determining the optimal replacement time for spares (spare parts) with an unacceptable interval, needs to account for:

A : The depreciated value of the equipment.

B : The value of money changing over time.

C : The interest charges for capital expenditures.

D : The cost of borrowing versus interest lost on operating funds.

Answer: B

Question 3

Motor current analysis reveals an unbalanced motor current in excess of 40% when the motor is loaded to over 70% of its nameplate full bad ampere rating. What should you suspect and or what should you do?

A : Do nothing. Current unbalance is normal in a motor that is not fully loaded.

B : Order the motor to be removed from service immediately, since failure due to overheated winding insulation is imminent.

C : Order more on-line tests to confirm the problem, allowing production to continue as long as possible.

D : Atthe first opportunity, shut down the motor and have motor circuit analysis performed to locate the cause so it can be corrected.

Answer: C

Question 4

What is a standard methodology to reduce or increase the frequency of a PM inspection?

A : Risk Based Inspection (RBI)

B : American National Standards Institute (ANSI)

C : American Petroleum Institute (API)

D : American Society of Mechanical Engineers (ASME)

Answer: A

Question 5

The measured units used for Mechanical Ultrasound are:

A : VAC

B : KHz

C : MHz

D : Hz

Answer: B

Page: 1 / 30

Total 150 Questions | Updated On: Jan 21, 2024

Add To Cart