Free GAQM CDCS-001 Exam Questions

Become GAQM Certified with updated CDCS-001 exam questions and correct answers

Page: 1 / 31

Total 152 Questions | Updated On: Jun 15, 2026

Add To Cart

Question 1

What mainly affects the cooling capacity of a raised floor tile?

A : Type of ICT equipment, location of the air conditioner, pressure under the raised floor, allowable temperature in the hot aisle

B : Relative humidity in the computer room, temperature of the cold air, pressure under the raised floor, construction material of the tile

C : Percentage of the surface opening, obstruction of the supporting construction, pressure under the raised floor, damper construction

D : Percentage of the surface opening, airflow direction of the ICT equipment, temperature difference between the air intake and air exhaust of the ICT equipment, construction material of the tile

Answer: C

Question 2

The pipes of a VESDA smoke detection system are installed at the air intake of the air conditioner inside the computer room. Is this a good practice from an early smoke detection point of view?

A : It depends on the type of gas-based fire suppression which will be installed.

B : Yes, as this reduces the amount of piping to be installed in the data center, as all air will go through the air conditioner.

C : No, the piping should be installed at the air exhaust of the air conditioner, as there can also be a fire inside the air conditioner itself.

D : No, it will give a longer reaction time for the smoke detection system and there might also be bypass airflow.

Answer: D

Question 3

Do you need to consider blast protection when designing a data center?

A : No, there is no reason for implementing blast protection as nobody can predict the impact of a bomb explosion.

B : Yes, if the data center is a potential target or the building is located within the vicinity of (close by) a potential target.

C : No, blast protection is not a requirement of ANSI/TIA-942.

D : Yes, blast protection is a requirement of ANSI/TIA-942.

Answer: B

Question 4

Is it allowed to make design changes during the implementation phase?

A : No, after a design freeze no further changes are allowed.3

B : Any change is fine as long as it is within the scope of the project.

C : Yes, but only when time to implement is not exceeded.

D : Only when there is a strong business and/or technical justification.