Free Cisco 300-630 Exam Questions

Become Cisco Certified with updated 300-630 exam questions and correct answers

Page: 1 / 25

Total 122 Questions | Updated On: Jun 03, 2025

Add To Cart

Question 1

300-630-page49-image21

Refer to the exhibit. An engineer must have communication between EPG1 in VRF1 and External EPG in

VRF2. Which three actions should be taken for the defined subnets in the L3Out External EPG to accomplish

this goal? (Choose three.)

A : able Shared Route Control Subnet

B : able External Subnets for External EPG

C : able Export Route Control Subnet

D : able Shared Security Import Subnet

E : able Aggregate Shared Routes

F : able Import Route Control Subnet

Answer: A,C,D

Question 2

Leaf 1002 receives a packet from a host attached to Leaf1001. The packet contains the MAC address, IP address, and VRF of the source. Which information does each node learn?

A : A. Leaf1002 learns the IP address of the source.Spine2001 learns the VRF of the source.

B : Leaf1002 learns the VRF of the source.Leaf1002 learns the IP address of the source.

C : Leaf1001 learns the MAC address of the source.Leaf1002 learns the IP address of the source.

D : Leaf1001 learns the IP address of the source.Spine2001 learns the IP address of the source.

Answer: B

Question 3

What are two PBR characteristics of the Cisco ACI Active-Active Across Pods deployment mode in Cisco ACI Multi-Pod design? (Choose two.)

A : Traffic is dynamically redirected to the firewall that owns the connection.

B : This mode causes the traffic to flow asymmetrically

C : Deployment occurs in go-to mode only.

D : Deployment occurs in transparent mode.

E : The connection state is unsynchronized.

Answer: B,D

Question 4

What is a characteristic of a stretched bridge domain solution between Cisco ACI sites with Layer 2 flood enabled?

A : BUM traffic between sites leverages ISN multicast replication.

B : The solution reduces control plane overhead.

C : Spine head-end replication is used to forward BUM traffic between sites.

D : Contracts are local to the provided site.

Answer: C

Question 5

What is the purpose of enabling ARP flooding when VMs are migrated from a pre-existing network to Cisco ACI and their gateways remain configured in the legacy setup?

A : to avoid endpoint flapping between the legacy network and the ACI fabric

B : to prevent VMs from communicating with physical servers within the ACI fabric

C : to allow communication between VMs and silent hosts

D : to allow VMs to communicate with devices outside of their subnet

Answer: A

Page: 1 / 25

Total 122 Questions | Updated On: Jun 03, 2025

Add To Cart