Free Cisco 300-425 Exam Questions

Become Cisco Certified with updated 300-425 exam questions and correct answers

Page: 1 / 52

Total 260 Questions | Updated On: Jan 06, 2026

Add To Cart

Question 1

An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets. Clients will be assigned a subnet by location. Which type of groups should the engineer use to map the smaller subnets to the corporate WLAN?

A : WLC port groups

B : RF groups

C : AP groups

D : interface groups

Answer: D

Question 2

An enterprise is using two wireless controllers to support the wireless network. The data center is located in the head office. Each controller has a corporate WLAN configured with the name Copr-NET392267230WLC-1 and Corp-NET68371638WLC-2. The APs are installed using a round-robin approach to load balance the traffic. What should be changed on the cofiguration to optimize roaming?

A : Use the same WLAN name for the corporate network on both controllers.

B : Move all access points to one controller and use the other as N+1 HA.

C : Move the controllers to an external data center with higher internet speeds

D : Place the access points per floor on the same controller.

Answer: D

Question 3

An engineer must produce a passive survey report. The coverage heat map shows the entire site with all signal levels. To see only the desired coverage, which action must the engineer take?

A : Change the color scheme to show the desired heat map.

B : Use the RSSI calibration tool to configure the receiver sensitivity.

C : Use the RSSI slider to set the heat map to the desired cutoff filter.

D : Filter the results to show the desired APs only.

Answer: D

Question 4

Refer to the exhibit. An engineer is about to establish a mobility peer connection between a Cisco Catalyst 9800-CL version 16.10.1e and Cisco AireOS 5520 version 8.8.120.0. The data path between the 9800-CL and AireOS 5520 is down, but its control path is up. Based on the configuration, what is the cause of the issue?

A : The certificate hash key is incorrect, which causes the data path to be down.

B : Encrypted mobility is being used in the 5520 configuration, which causes the data path to be down.

C : The data-dtls is disabled on the AireOS 5520 WLC, which causes the data path to be down.

D : The data-link-encryption configuration is missing from the 9800-CL configuration.

Answer: C

Question 5

A wireless engineer must optimize RF performance for multiple buildings with multiple types of construction and user density. Which two actions must be taken? (Choose two.)

A : Configure FlexConnect groups for each building.

B : Configure WMM profiles for each building.

C : Configure AP groups for each area type.

D : Configure RF profiles for each area type.

E : Enable DTPC on the network.

Answer: C,D

Page: 1 / 52

Total 260 Questions | Updated On: Jan 06, 2026

Add To Cart