Free Oracle 1Z0-822 Exam Questions

Become Oracle Certified with updated 1Z0-822 exam questions and correct answers

Page: 1 / 29

Total 141 Questions | Updated On: Apr 29, 2026

Add To Cart

Question 1

You are tasked to reconfigure zone1 to use virtual interface vnic1 as its network interface. Which two steps must be included?

A : Disable IP Filter and IPsec.

B : Configure the NWAM NCP to Automatic.

C : Change the shared IP zone to an exclusive IP zone.

D : Reboot zonal so that changes made with zonecfq take effect.

E : From the global zone, set the IP address of vnic1 and configure the default route.

Answer: A,C

Question 2

You must configure your server to use IPMP with probe based failure detection enabled. Which statement is a valid constraint or feature that applies to this requirement?

A : Link-based detection is supported only on Genetic Land Driver version 2 (GLDv2)-complaint NICs.

B : GLDv2 NICs are not supported in Oracle Solaris 11.

C : GLDv3 NICs configured for link based detection by default.

D : You must first disable link based detection before configuring probe-based failure detection.

Answer: D

Question 3

Consider the following command:

dispadmin -c IA -g -r 1000000

Which statement correctly describes the result?

A : The quantum will be reported in milliseconds.

B : The quantum will be output every 1000000 milliseconds.

C : The quantum will be reported in microseconds.

D : The quantum will be output every 1000000 microseconds.

Answer: A

Question 4

There is a valid SMF manifest located underneath the /var/svc/manifest directory. Which four methods can be used to add it to the services repository?

A : Reboot the system.

B : Restart the early-manifest-import service.

C : Use the svccfg apply command.

D : Restart the manifest-import service.

E : Use the svccfg import command.

Answer: A,B,C,D

Question 5

Which two zpool subcommands will permanently remove a submirror from active storage pool?

A : remove

B : detach

C : destroy

D : offline

E : replace

F : split

G : zpool does not permit this operation on an active storage pool unless the submirror faults.

Answer: A,B

Page: 1 / 29

Total 141 Questions | Updated On: Apr 29, 2026

Add To Cart