Free Oracle 1Z0-404 Exam Questions

Become Oracle Certified with updated 1Z0-404 exam questions and correct answers

Page: 1 / 15

Total 75 Questions | Updated On: Mar 13, 2026

Add To Cart

Question 1

After configuring Header Manipulation Rules (HMRs) for topology hiding, your subsequent testing shows that the manipulation is not takingeffect. Identify two causes for this (Choose two.)

A : You have not configured the out-manipulationid parameter of the sip-interface configuration element.

B : You have not enabled policy-based realm-bridging

C : The value of the name parameter in the header-rule configuration element is different than the value of the out-manipulationid parameter in the sip-interface configuration element.

D : The value of the match-val-type parameter is not written correctly

E : The home-proxy-address value does not matchthe $LOCAL_IP value in the new-value parameter.

Answer: A,E

Question 2

What is the first thing you should do when you want the Session Border Controller to detect that anendpoint is behind a NAT/firewall device?

A : Navigate to the sip-port configuration element and set the nat-traversal parameter to disabled

B : Navigate to the sip-interface configuration element and set the nat-traversal parameter to never.

C : Navigate to the sip-interface configuration element and set the nat-traversal parameter to always

D : Navigate to the sip-port configuration element and set the nat-traversal parameter to enabled.

E : Navigate to the sip-interface configuration element and set the nat-traversal parameter to detect

Answer: C

Question 3

Which two states are needed by the active node while transitioning to standby? (Choose two.)

A : Out of service

B : Becoming-active

C : Relinquishing-standby

D : Relinquishing-active

E : Becoming-standby

Answer: B,D

Question 4

You are configuring a network interface to enable the Session Border Controller to use the interface for signaling and media. Identify two valid configuration steps for supporting VLAN 12 (Choose two.)

A : Navigate to the network-interface configuration element and set the sub-port-id parameter to 12.

B : Navigate to the network-interface configuration element and set the sub-port-id parameter to 0.

C : Navigate to the phy-interface configuration element and configure the hip-id parameter.

D : Navigate to the phy-interface configuration element and configure the pri-utility-address parameter.

E : Navigate to the network-interface configuration element and configure the name parameter.

Answer: A,C

Question 5

You want to prevent the Session Border Controller from generating aunique Call-ID and from modifying the dialog tags. How would you accomplish this?

A : Navigate to the sip-interface configuration element and set the dialog-transparency parameter to disabled

B : Navigate to the sip-config configuration element and set the dialog-mapping parameter to disabled.

C : Navigate to the sip-config configuration element and set the call-id-transparency parameter to disabled.

D : Navigate to the sip-config configuration element and set the dialog-transparency parameter to disabled.

E : Navigate to the sip-config configuration element and set the dialog-transparency parameter to enabled.

Answer: E

Page: 1 / 15

Total 75 Questions | Updated On: Mar 13, 2026

Add To Cart